Cooling Towers For Weather Modification? Absolute Nonsense
I have had a number of people request that I address the completely ridiculous information being put out by some stating that power plant cooling towers are being used for climate modification. I have not written about this disinformation until now as the cooling tower conclusion is so ludicrous that I felt it did not need to be “debunked”. This being said, some published pictures of the steam plumes above cooling towers could be confusing to those that have not done the math.
I have personally worked on cooling towers for Bechtel Power over three decades ago. The facility I was involved with was the “Coolwater Coal Gassification Project” located in Dagget, California. Dagget is in the middle of the Mojave Desert. How much available water is there in this desert? Not much, and for this reason these cooling towers were a “closed loop” system. Most power plants use the “closed loop” system to conserve water. Also,many power plants use steam powered generators, how can they not generate steam? In comparison to even the smallest of rainstorms, the amount of water vapor put out by the cooling towers is barely a drop in the ocean. As already mentioned, many facilities simply recirculate the water, only losing a slight amount to steam. The “cooling ponds” that supply the water for the steam generating plants are not very large and are supplied by conventional wells in many cases. People need to picture the amount of water that pours out of the sky which can form huge lakes and rivers in a very short time. To believe that isolated steam cooling towers could magically put this volume of water into the sky from water sources that are often only ponds fed by wells (often with only 4 inch feed pipes) is beyond ridiculous. Many have unfortunately mistaken the formation of convective storms as being the result of cooling towers. This conclusion is patently false. We must all use our sense of reason and avoid conclusions that come from an impressive picture (or satellite look video) without due consideration. Though there is much we can not yet know about in regard to the full spectrum of the climate modification programs or the mechanisms that carry these programs out, the cooling tower moisture supply theory should be buried in the tomb of the totally impossible. The article below will add further detail to this subject.
How it Works: Water for Power Plant Cooling
Source: Union of Concerned Scientists
In the United States, 90 percent of electricity comes from thermoelectric power plants—coal, nuclear, natural gas, and oil—that require cooling. The remaining ten percent is produced by hydroelectric and other renewable energy facilities. Some renewable energy technologies are thermoelectric as well, including certain types of concentrating solar, geothermal, and biomass power plants.
1. Why is Cooling Necessary?
2. Types of Cooling
3. Electricity Generation Technologies that Use Cooling
4. Other Key Issues
Why is Cooling Necessary?
Thermoelectric power plants boil water to create steam, which then spins turbines to generate electricity. The heat used to boil water can come from burning of a fuel, from nuclear reactions, or directly from the sun or geothermal heat sources underground. Once steam has passed through a turbine, it must be cooled back into water before it can be reused to produce more electricity. Colder water cools the steam more effectively and allows more efficient electricity generation 
Types of Cooling
Even though all thermoelectric plants use water to generate steam for electricity generation, not all plant cooling systems use water. There are three main methods of cooling:
- Once-through systems take water from nearby sources (e.g., rivers, lakes, aquifers, or the ocean), circulate it through pipes to absorb heat from the steam in systems called condensers, and discharge the now warmer water to the local source. Once-through systems were initially the most popular because of their simplicity, low cost, and the possibility of siting power plants in places with abundant supplies of cooling water. This type of system is currently widespread in the eastern U.S. Very few new power plants use once-through cooling, however, because of the disruptions such systems cause to local ecosystems from the significant water withdrawals involved and because of the increased difficulty in siting power plants near available water sources.
- Wet-recirculating or closed-loop systems reuse cooling water in a second cycle rather than immediately discharging it back to the original water source. Most commonly, wet-recirculating systems use cooling towers to expose water to ambient air. Some of the water evaporates; the rest is then sent back to the condenser in the power plant. Because wet-recirculating systems only withdraw water to replace any water that is lost through evaporation in the cooling tower, these systems have much lower water withdrawals than once-through systems, but tend to have appreciably higher water consumption. In the western U.S., wet-recirculating systems are predominant.
- Dry-cooling systems use air instead of water to cool the steam exiting a turbine. Dry-cooled systems use no water and can decrease total power plant water consumption by more than 90 percent. The tradeoffs to these water savings are higher costs and lower efficiencies. In power plants, lower efficiencies mean more fuel is needed per unit of electricity, which can in turn lead to higher air pollution and environmental impacts from mining, processing, and transporting the fuel. In 2000, most U.S. dry-cooling installations were in smaller power plants, most commonly in natural gas combined-cycle power plants.
About 43 percent of thermoelectric generators in the United States use once-through cooling, 56 percent recirculating, and 1 percent dry-cooling (2008 data). In 2008, some 30 percent of electricity generation involved once-through cooling, 45 percent recirculating cooling, and 2 percent dry-cooling. (In some cases, those same power plants also produced electricity using non-steam systems, such as combustion turbines.)
Table 1: Water withdrawn and consumed for power plant cooling, in gallons of water required per megawatt-hour of electricity produced
Electricity Generation Technologies that Use Cooling
- Concentrating solar (solar thermal electric)
Other Key Issues
- Siting: The geographic location of power plants has a huge impact on cooling technology options, water availability, type of water used for cooling, and environmental impacts. Solar and geothermal power plants, for example, must be sited in areas with high solar radiation and geothermal energy, respectively—locations that may be arid and far from conventional water resources. In these situations, dry cooling may be an option, or alternative water sources may be available, but such choices can affect power plant performance and local environments.
- Water type: Although many power plants use freshwater for cooling, waste water and salt water are other possibilities with advantages and disadvantages. Salt water is an obvious and abundant option for coastal power plants, for example, but such plants face similar challenges as inland plants with regard to damaging the local aquatic ecosystems through excessive withdrawals or thermal pollution (from discharges of hot cooling water.
 U.S. Department of Energy (DOE), 2008. Estimating Freshwater Needs to Meet Future Thermoelectric Generation Requirements. Washington, DC.
 Though no water is required for dry-cooling systems, power plants using dry-cooling systems also require water for system maintenance and cleaning.
 Small power plants are defined as having an electric generating capacity less than 300 MW. Dougherty, B., Page, T., & Bernow, S. 2000. Comments on the EPA’s Proposed Regulations on Cooling Water Intake Structures for New Facilities. Boston, MA: Tellus Institute.
 Union of Concerned Scientists. 2012. UCS EW3 Energy-Water Database V.1.3. www.ucsusa.org/ew3database.
 J. Macknick, R. Newmark, G. Heath, and K.C. Hallet. 2012. Operational water consumption and withdrawal factors for electricity generating technologies: a review of existing literature. Environmental Research Letters. 7 doi:10.1088/1748-9326/7/4/045802.
 Some concentrating solar technologies do not use water for generating electricity.
Source: Union of Concerned Scientists